The Husqvarna 240440 is a 24 HP, 44-inch cut riding lawn mower designed for residential use. It features a Briggs & Stratton engine, hydrostatic transmission, electric start, cruise control, adjustable cutting height, and a comfortable high-back seat. Below are key sections for safety, features, operation, maintenance, and troubleshooting.
Key components: 24 HP Briggs & Stratton engine, 44-inch stamped steel cutting deck, Hydrostatic transmission, Electric start with key, Cruise control, Adjustable high-back seat, Headlights, Cup holder.
| Feature | Description |
|---|---|
| Engine | 24 HP Briggs & Stratton, single cylinder, air-cooled |
| Cutting Width | 44 inches |
| Transmission | Hydrostatic, foot pedal control |
| Starting System | Electric key start with 12V battery |
| Cutting Height | Adjustable from 1.5 to 4 inches |
| Deck Engagement | Electric PTO (Power Take-Off) lever |
| Fuel Capacity | 3 gallons |
| Seat | Adjustable high-back with armrests |
| Speed Control | Forward/Reverse pedals, cruise control |
| Headlights | Integrated for low-light operation |
Read all instructions before operating. Always wear appropriate safety gear.
WARNING! Gasoline is flammable; refuel outdoors with engine off and cool. Keep children and pets away during operation.
Unpack and inspect contents. Assembly requires basic tools.
CAUTION! Ensure all bolts are tightened securely. Test controls before first use.
Dashboard: Ignition key, PTO lever, throttle, choke, hour meter. Floor: Forward/reverse pedals, brake pedal.
Starting: 1. Sit on seat. 2. Set parking brake. 3. Disengage PTO. 4. Move throttle to choke (cold) or fast. 5. Turn key to START.
Driving: Release parking brake. Press forward pedal to go forward, reverse pedal to go backward. Speed controlled by pedal pressure.
Mowing: Engage PTO lever to start blades. Adjust cutting height with lever (1.5 to 4 inches).
Stopping: Disengage PTO, move throttle to slow, turn key to OFF, set parking brake.
For best results, mow when grass is dry.
Tip: Sharpen blades every 25 hours for clean cut.
Regular maintenance ensures long life and performance.
| Interval | Task |
|---|---|
| Before each use | Check tire pressure, fuel level, look for leaks |
| Every 8 hours | Check engine oil level |
| Every 25 hours | Sharpen/replace blades, check battery terminals |
| Every 50 hours | Change engine oil, replace oil filter |
| Every 100 hours | Replace air filter, spark plug |
| Seasonally | Grease fittings, check belts for wear |
Oil Change: Run engine to warm oil, drain via plug, refill with 2 quarts SAE 30.
Prepare mower for off-season storage.
CAUTION! Do not store with fuel in tank without stabilizer. Gasoline degrades over time.
| Symptom | Possible Cause | Corrective Action |
|---|---|---|
| Engine won't start | Dead battery, empty fuel, bad spark plug | Charge/replace battery; add fuel; check/replace spark plug. |
| Engine runs rough | Dirty air filter, old gasoline | Replace air filter; drain old fuel, add fresh. |
| Uneven cutting | Dull blades, uneven tire pressure | Sharpen blades; adjust tire pressure to spec. |
| Loss of power | Clogged deck, worn drive belt | Clean deck underside; inspect/replace drive belt. |
| Hydrostatic transmission sluggish | Low fluid, air in system | Check fluid level; bleed air per manual. |
Reset: Disconnect battery for 5 minutes to reset electrical system if needed.
Husqvarna 240440 includes a 2-year limited warranty for residential use. Warranty covers defects in materials and workmanship. Not covered: normal wear, improper maintenance, commercial use, accidents. For warranty service, contact authorized Husqvarna dealer with proof of purchase. For support, visit www.husqvarna.com or contact 1-800-487-5962.