Husqvarna GT2254 Manual Owner's Manual

The Husqvarna GT2254 is a 22-horsepower, 54-inch cutting width garden tractor designed for residential lawn care. It features a Kohler Command Pro engine, hydrostatic transmission, electric PTO clutch, power steering, cruise control, and a comfortable high-back seat. Below are key sections for safety, features, operation, maintenance, and troubleshooting.

1. Features at a Glance 2. Assembly & Setup 3. Controls and Operation 4. Specifications 5. Maintenance Schedule 6. Engine Care 7. Mower Deck Maintenance 8. Storage & Winterization 9. Safety Information 10. Warranty Information 11. Troubleshooting

Features at a Glance

Key components: 22 HP Kohler Command Pro OHV engine, 54-inch fabricated mower deck, Hydrostatic transmission, Electric PTO clutch, Power steering, Cruise control, 3.5-gallon fuel tank, Headlights, Hour meter.

Feature	Description
Engine	22 HP Kohler Command Pro, 2-cylinder, OHV
Cutting Width	54-inch fabricated steel deck
Transmission	Hydrostatic, infinite forward/reverse speeds
PTO Clutch	Electric engagement
Steering	Power-assisted
Cruise Control	Maintains constant speed
Fuel Capacity	3.5 gallons
Seat	High-back, adjustable
Headlights	Integrated for low-light operation
Hour Meter	Tracks engine hours for maintenance

Assembly & Setup

Unpack and inspect contents. Assembly required for steering wheel, seat, and mower deck.

Install steering wheel: Align and secure with provided hardware.
Attach seat: Mount to seat plate using bolts and washers.
Connect mower deck: Lower deck lift, align with attachment points, secure with pins and belts.
Check tire pressure: Inflate to 12 PSI (front) and 10 PSI (rear).
Add engine oil and fuel: Use SAE 10W-30 oil and unleaded gasoline.

WARNING! Tractor is heavy; use assistance during assembly. Ensure all bolts are tightened securely.

Controls and Operation

Access controls from operator seat. Ignition switch, throttle, choke, PTO switch, deck lift lever, brake pedal, cruise control.

Starting Procedure:

Set parking brake.
Move PTO switch to OFF.
Adjust throttle to midway.
Turn ignition key to START.
Release key to RUN position once engine starts.

Mowing: Engage PTO switch, adjust speed with hydrostatic pedal, use deck lift to set cutting height (1.5-4.5 inches).

Stopping: Disengage PTO, set parking brake, turn ignition OFF.

Specifications

Engine: Kohler Command Pro, 22 HP, 2-cylinder, OHV.
Cutting Width: 54 inches.
Transmission: Hydrostatic, infinite speeds.
Fuel Capacity: 3.5 gallons.
Cutting Heights: 1.5 to 4.5 inches (adjustable in 0.25-inch increments).
Turning Radius: 18 inches.
Weight: 650 lbs (approx.).
Warranty: 2-year limited warranty.

Maintenance Schedule

Regular maintenance ensures optimal performance and longevity.

Interval	Task
Before each use	Check engine oil level, tire pressure, and fuel level
First 5 hours	Change engine oil and filter
Every 50 hours	Change engine oil, check air filter, inspect blades
Every 100 hours	Replace air filter, check spark plugs, lubricate fittings
Every season	Sharpen/replace blades, check belts, clean deck

Engine Care

Kohler Command Pro engine requires regular oil changes and air filter maintenance.

Oil Change: Run engine to warm oil, drain via plug, refill with SAE 10W-30 (approx. 2 quarts).
Air Filter: Replace paper element every 100 hours; clean foam pre-cleaner if equipped.
Spark Plugs: Gap to 0.030 inches; replace annually or every 100 hours.
Fuel System: Use fresh unleaded gasoline; add fuel stabilizer for storage.

CAUTION! Engine is hot after operation; allow to cool before maintenance.

Mower Deck Maintenance

54-inch fabricated deck requires blade sharpening, belt inspection, and cleaning.

Blade Sharpening: Disconnect spark plug, remove deck, sharpen blades evenly.
Belt Tension: Check for wear; adjust idler pulley if slack.
Deck Cleaning: Remove grass clippings and debris after each use.
Spindle Lubrication: Grease fittings every 25 hours.

WARNING! Always disconnect spark plug before servicing deck or blades.

Storage & Winterization

Prepare tractor for off-season storage.

Add fuel stabilizer to tank and run engine for 5 minutes.
Change engine oil and filter.
Remove battery and store in cool, dry place.
Clean deck and underside thoroughly.
Store in covered, dry location.

CAUTION! Do not store with fuel in tank without stabilizer; may cause carburetor issues.

Safety Information

Read and follow all safety instructions to prevent injury.

Wear eye protection and sturdy footwear.
Keep hands and feet away from moving parts.
Do not mow on slopes greater than 15 degrees.
Clear area of debris before mowing.
Never carry passengers.
Disengage PTO and set parking brake before dismounting.

DANGER! Rotating blades can cause severe injury; always shut off engine before servicing.

Warranty Information

Husqvarna GT2254 includes a 2-year limited warranty for residential use. Warranty covers defects in materials and workmanship. Not covered: normal wear, improper maintenance, commercial use. For warranty claims, contact authorized Husqvarna dealer with proof of purchase. For support, visit www.husqvarna.com or call 1-800-487-5962.

Troubleshooting

Symptom	Possible Cause	Corrective Action
Engine won't start	Dead battery, empty fuel, clogged filter	Charge battery; add fuel; replace fuel filter.
Poor cutting performance	Dull blades, low engine speed	Sharpen blades; adjust throttle to full speed.
Excessive vibration	Unbalanced blade, loose parts	Balance or replace blade; tighten bolts.
Hydrostatic transmission sluggish	Low fluid, dirty filter	Check fluid level; replace filter if equipped.
PTO won't engage	Blown fuse, faulty switch	Check 20-amp fuse; test PTO switch.

Reset: Check all safety switches (seat, brake, PTO) are functioning.

Service: 1-800-487-5962; www.husqvarna.com