Husqvarna Mower LGT 2654 Owners Manual

The Husqvarna LGT 2654 is a 26 HP Kohler engine, 54-inch cutting deck lawn tractor designed for residential use. It features hydrostatic transmission, electric PTO clutch, cruise control, adjustable cutting height, headlights, cup holder, and a comfortable high-back seat. Below are key sections for safety, operation, maintenance, specifications, and troubleshooting.

1. Features at a Glance 2. Safety Information 3. Assembly & Setup 4. Specifications 5. Controls and Operation 6. Mowing Instructions 7. Maintenance Schedule 8. Storage 9. Troubleshooting 10. Warranty Information

Features at a Glance

Key components: 26 HP Kohler V-Twin engine, 54-inch fabricated steel cutting deck, Hydrostatic transmission, Electric PTO clutch, Cruise control, Adjustable seat, Headlights, Cup holder, Hour meter.

Feature	Description
Engine	26 HP Kohler V-Twin, 4-cycle, air-cooled
Cutting Deck	54-inch fabricated steel, 3-blade
Transmission	Hydrostatic, infinite forward/reverse speeds
PTO Clutch	Electric engagement
Cutting Height	Adjustable from 1.5 to 4.5 inches
Fuel Capacity	3.5 gallons
Seat	High-back, adjustable
Headlights	Two front headlights for low-light operation
Cruise Control	Maintains constant speed without holding lever
Hour Meter	Tracks engine hours for maintenance

Safety Information

Read all instructions before operating. Always wear appropriate safety gear.

Clear mowing area of debris, toys, and obstacles.
Never allow children or pets in area while mowing.
Do not mow on slopes greater than 15 degrees.
Always disengage PTO and set parking brake before leaving operator's position.
Stop engine and remove key before performing maintenance.

WARNING! Rotating blades can cause severe injury. Keep hands and feet away from deck while engine is running. Always look behind when backing up.

Assembly & Setup

Unpack and inspect all parts. Assembly requires basic tools.

Install steering wheel: Align and tighten bolt.
Attach seat: Mount to frame with provided bolts.
Connect battery: Attach red (+) then black (-) cables.
Check tire pressure: Inflate to 14 PSI (front) and 10 PSI (rear).
Add engine oil: Use SAE 10W-30, fill to dipstick "Full" mark.
Add fuel: Use unleaded gasoline with minimum 87 octane.

CAUTION! Ensure all bolts are tightened securely. Check for loose parts before operation.

Specifications

Model: LGT 2654
Engine: 26 HP Kohler V-Twin, 4-cycle
Cutting Width: 54 inches
Transmission: Hydrostatic
Fuel Capacity: 3.5 gallons
Oil Capacity: 2.0 quarts
Cutting Height Range: 1.5 - 4.5 inches
Turning Radius: 18 inches
Weight: 580 lbs
Warranty: 3-year limited

Controls and Operation

Familiarize yourself with all controls before starting.

Control Panel: Ignition switch, PTO engagement lever, Choke, Throttle, Cruise control, Hour meter, Light switch.

Operation Steps:

Park on level surface, set parking brake.
Move PTO lever to OFF position.
Adjust throttle to midway position.
Turn ignition key to START; release when engine starts.
Allow engine to warm up for 30 seconds.
Release parking brake, slowly press forward pedal to move.
Engage mower blades by pulling PTO lever up.

Stopping: Disengage PTO, reduce speed, engage parking brake, turn key to OFF.

Mowing Instructions

For best results, follow these mowing practices.

Mow when grass is dry for even cut.
Adjust cutting height based on grass type and season.
Overlap each pass by 2-3 inches to avoid streaks.
Change mowing pattern weekly to prevent grass matting.
Mow slopes up and down, not across.
Reduce speed in rough or uneven terrain.
Disengage blades when crossing driveways or gravel.

Tip: Keep blades sharp for clean cut and better fuel efficiency.

Maintenance Schedule

Regular maintenance ensures long life and optimal performance.

Interval	Task
Before each use	Check tire pressure, inspect for damage, check oil level
Every 8 hours	Clean deck underside, check blade condition
Every 50 hours	Change engine oil, replace oil filter
Every 100 hours	Replace air filter, spark plugs
Every season	Sharpen blades, lubricate fittings, check battery
Every 2 years	Replace fuel filter, change transmission fluid

Note: Refer to engine manual for specific engine maintenance.

Storage

Proper storage prevents damage during off-season.

Clean entire mower, especially underside of deck.
Drain fuel or add fuel stabilizer to full tank.
Change oil and filter.
Remove spark plug, add teaspoon of oil to cylinder, pull starter cord slowly to distribute.
Disconnect battery, store in cool dry place.
Store in clean, dry area, cover with breathable cover.

CAUTION! Never store with fuel in tank near open flame or heat source.

Troubleshooting

Symptom	Possible Cause	Corrective Action
Engine won't start	Dead battery, empty fuel, safety switch engaged	Charge battery, add fuel, ensure seat is occupied and PTO disengaged.
Poor cutting performance	Dull blades, low engine speed, clogged deck	Sharpen blades, run at full throttle, clean deck underside.
Excessive vibration	Unbalanced blade, loose blade bolt, damaged spindle	Stop engine immediately, check blade balance and tightness, inspect spindle.
Loss of power	Clogged air filter, old fuel, dirty spark plug	Replace air filter, drain old fuel, clean or replace spark plug.
Hydrostatic transmission slips	Low fluid, drive belt worn	Check fluid level, inspect and replace drive belt if necessary.

Reset: Disconnect battery for 5 minutes to reset electrical system if needed.

Service: 1-800-487-5952; www.husqvarna.com

Warranty Information

Husqvarna LGT 2654 includes a 3-year limited warranty for residential use. Warranty covers defects in materials and workmanship. Not covered: normal wear, improper maintenance, accident, commercial use. Keep original receipt for warranty claims. For warranty service, contact authorized Husqvarna dealer.