Husqvarna Mowers Z246 Owners Manual

The Husqvarna Z246 is a 24 HP Zero-Turn Riding Mower featuring a Kohler 7000 Series engine, 46-inch fabricated cutting deck, hydrostatic zero-turn transmission, electric PTO engagement, adjustable high-back seat, and dual-lever steering controls. Designed for residential use on medium to large lawns. Below are key sections for safety, features, operation, maintenance, and troubleshooting.

Features at a Glance

Key components: 24 HP Kohler engine, 46-inch fabricated steel deck, Hydro-Gear EZT transmission, electric PTO clutch, adjustable seat, dual lap bars for steering, 12V battery, fuel tank, and mulching/discharge capability.

Assembly & Setup

Unpack and inspect all parts. Assembly requires basic tools.

1. Install steering levers: Attach to control panel per diagram.
2. Attach seat: Bolt seat to frame; adjust position.
3. Connect battery: Attach red (+) then black (-) terminals.
4. Add engine oil: Use SAE 10W-30; fill to dipstick mark.
5. Add fuel: Use unleaded gasoline (87 octane min).
6. Check tire pressure: Inflate to 14 PSI (front) and 10 PSI (rear).

WARNING! Mower is heavy; use assistance. Ensure all bolts are tightened securely.

Controls & Operation

Familiarize yourself with controls before starting.

1. Pre-start check: Oil level, fuel, tire pressure, deck clear.
2. Starting: Sit on seat, set parking brake, move levers to neutral, turn key.
3. Driving: Slowly push levers forward to move; pull back to reverse.
4. Mowing: Engage PTO switch; adjust speed with throttle.
5. Stopping: Disengage PTO, return levers to neutral, set brake, turn key off.

CAUTION! Keep hands and feet away from moving parts. Do not mow on slopes over 15 degrees.

Specifications

• Model: Husqvarna Z246.
• Engine: Kohler 7000 Series, 24 HP, 725cc.
• Cutting Deck: 46-inch fabricated, 10-gauge steel.
• Transmission: Hydro-Gear EZT, zero-turn.
• Speed: Up to 6.5 mph forward, 3 mph reverse.
• Fuel Type: Unleaded gasoline (87 octane minimum).
• Oil Capacity: 2 quarts (1.9 L) SAE 10W-30.
• Weight: 580 lbs (263 kg).
• Warranty: 3-year limited.

Maintenance Schedule

Regular maintenance ensures longevity and performance.

Cutting Deck Adjustment

Proper deck leveling ensures even cut.

1. Park on level surface; set height to middle position.
2. Measure blade tip height on all sides; adjust lift links.
3. Check front-to-back pitch: Front should be 1/4-inch lower than rear.
4. Tighten adjustment nuts securely after leveling.

Tip: Disconnect spark plug before adjusting or servicing deck.

Engine Care

Kohler 7000 Series engine maintenance.

1. Oil change: Warm engine, drain via plug, refill with SAE 10W-30.
2. Air filter: Replace paper element; clean pre-cleaner if equipped.
3. Spark plug: Gap at 0.030 inches; replace annually.
4. Fuel system: Use fresh fuel; add stabilizer for storage.

WARNING! Engine is hot after operation; allow to cool before servicing.

Storage & Winterization

Prepare mower for off-season storage.

1. Add fuel stabilizer; run engine for 5 minutes.
2. Change oil and filter.
3. Remove battery; store in cool, dry place.
4. Clean deck thoroughly; lubricate moving parts.
5. Store in dry, covered area.

CAUTION! Do not store with fuel in tank over 30 days without stabilizer.

Safety Information

Read and follow all safety instructions.

• Wear eye protection, sturdy shoes, long pants.
• Clear mowing area of debris, rocks, toys.
• Do not carry passengers.
• Do not mow on steep slopes or wet grass.
• Disengage PTO before crossing drives or gravel.
• Keep hands and feet away from deck while engine is running.

Warranty & Support

Husqvarna Z246 includes a 3-year limited warranty for residential use. Warranty covers defects in materials/workmanship. Normal wear, misuse, or lack of maintenance not covered. For support, visit www.husqvarna.com or contact 1-800-487-5962. Keep your receipt and model/serial numbers for service.

Troubleshooting

Reset: Check all safety interlock switches if engine does not crank.

Service: 1-800-487-5962; www.husqvarna.com