Owners Manual for Husqvarna LC221A Lawn Mower

The Husqvarna LC221A is a 21-inch, 3-in-1 push lawn mower featuring a 140cc Briggs & Stratton engine, 7-position single-lever cutting height adjustment, 2.1 bushel rear bagger, side discharge, and mulching capability. It includes a durable steel deck, ergonomic handle with easy-fold system, and washout port for easy cleaning. Below are key sections for safety, features, assembly, operation, maintenance, and troubleshooting.

1. Features at a Glance 2. Assembly Instructions 3. First-Time Setup 4. Specifications 5. Controls and Operation 6. Cutting Height Adjustment 7. Maintenance Schedule 9. Storage & Winterization 10. Safety Information 11. Warranty & Support 12. Troubleshooting

Features at a Glance

Key components: 140cc Briggs & Stratton engine, 21-inch steel cutting deck, 7-position height adjustment lever, rear grass bag, side discharge chute, mulching plug, washout port, foldable handle.

Feature	Description
Engine	140cc Briggs & Stratton 450E Series, 4-cycle
Cutting Width	21 inches
Cutting Options	Rear Bag, Side Discharge, Mulch
Cutting Height	7 positions (1.25" - 3.75")
Deck Material	Powder-coated steel
Grass Bag Capacity	2.1 bushels
Handle	Ergonomic, foldable for storage
Washout Port	For easy deck cleaning
Wheels	8-inch rear, 7-inch front
Starter	Recoil (pull-start)

Assembly Instructions

Unpack and inspect all parts. Assembly requires basic tools (included).

Attach Lower Handle: Bolt lower handle sections to deck using provided hardware.
Attach Upper Handle: Connect upper handle to lower handle; secure with knobs.
Install Grass Bag: Attach bag frame to rear brackets; hang bag.
Install Side Discharge Chute: If using, attach to side discharge opening.
Install Mulching Plug: For mulching, insert plug into rear discharge opening.
Add Oil & Gas: Fill engine with SAE 30 oil (check dipstick). Add unleaded gasoline.

WARNING! Wear gloves during assembly. Ensure all bolts are tight before operation.

First-Time Setup

Before first use, complete final checks and adjustments.

Check Oil Level: Ensure oil is at full mark on dipstick.
Add Fuel: Use fresh unleaded gasoline (87 octane or higher).
Adjust Cutting Height: Set lever to desired position (middle setting recommended).
Select Cutting Mode: Install bag, side chute, or mulching plug as needed.
Test Start: Pull starter cord smoothly to start engine.

CAUTION! Operate outdoors only. Keep area clear of bystanders, especially children.

Specifications

Model: Husqvarna LC221A
Engine: Briggs & Stratton 450E, 140cc, 4-cycle
Cutting Width: 21 inches
Cutting Height Range: 1.25" - 3.75" (7 positions)
Deck: 21-inch steel, powder-coated
Grass Bag Capacity: 2.1 bushels
Wheels: 8" rear, 7" front
Weight: 65 lbs (approx.)
Fuel Tank Capacity: 0.95 quarts
Oil Capacity: 20 oz (SAE 30)

Controls and Operation

Handle Controls: Drive control bar (must be held to engage wheels), height adjustment lever, engine control lever.

Starting Procedure:

Check oil and fuel levels.
Move engine control lever to START position.
Prime engine (if equipped) by pressing primer bulb 3 times.
Pull starter cord briskly until engine starts.
To engage self-propel (if equipped), squeeze drive control bar while walking.

Stopping: Release drive control bar, move engine control lever to STOP.

Cutting Height Adjustment

Single-lever adjustment for all four wheels.

Stop engine and wait for blade to stop completely.
Pull height adjustment lever toward wheel.
Move lever to desired position (1-7, lowest to highest).
Release lever to lock in position.
Check that all wheels are at same height.

Tip: For first cut of season or overgrown grass, use highest setting, then lower gradually.

Maintenance Schedule

Regular maintenance ensures optimal performance and longevity.

Interval	Task
Before each use	Check oil level, inspect blade for damage, clear deck of debris
Every 25 hours	Change engine oil, check air filter, inspect spark plug
Every season	Sharpen or replace blade, clean underside of deck, check wheels
As needed	Replace air filter, spark plug, clean fuel system

Blade Sharpening: Remove blade; sharpen at original angle (balance after sharpening).

Storage & Winterization

Prepare mower for extended storage (especially winter).

Run engine to warm oil, then drain oil completely.
Add fresh oil or fogging oil per engine manual.
Drain fuel tank or add fuel stabilizer and run engine 5 minutes.
Clean deck thoroughly using washout port.
Remove spark plug, add teaspoon of oil, pull starter slowly.
Store in dry, covered area.

CAUTION! Never store with gasoline in tank indoors. Disconnect spark plug wire before maintenance.

Safety Information

DANGER! Rotating blade can cause severe injury. Always follow safety rules.

Read manual completely before operation.
Clear mowing area of stones, sticks, and debris.
Wear sturdy shoes, long pants, and eye protection.
Never mow wet grass.
Never allow children to operate mower.
Stop engine and wait for blade to stop before crossing drives or adjusting height.
Disconnect spark plug wire before performing maintenance.

Warranty & Support

Husqvarna Limited Warranty: 2-year residential warranty from date of purchase. Proof of purchase required. Warranty covers defects in materials/workmanship; does not cover normal wear, misuse, or lack of maintenance. For support, visit www.husqvarna.com/us or contact 1-800-487-5962.

Troubleshooting

Symptom	Possible Cause	Corrective Action
Engine won't start	No fuel, old gas, clogged filter	Check fuel level; use fresh gas; clean/replace air filter.
Engine runs poorly	Dirty air filter, old gas	Replace air filter; drain and refill with fresh gasoline.
Uneven cut	Dull blade, uneven tire pressure	Sharpen or replace blade; check tire pressure/wheel height.
Vibration	Loose blade, bent blade	Tighten blade bolt; replace bent blade.
Grass not discharging	Wet grass, clogged deck	Mow when grass is dry; clean underside of deck.
Self-propel not working	Drive cable loose, worn drive belt	Adjust drive cable; replace drive belt if worn.

Service: For repairs, contact authorized Husqvarna service dealer.

Parts: Use only genuine Husqvarna replacement parts.